Smallness of the hole is odd not, I did not pass through the tool of KWT that has been used until now.
I had been in and out of the snap ring of the same 8mm.
Forced I purchased a tool Knipex.
Still, it is a thin meat in the vicinity of the hole. Only to the locations to use in response to the thrust bearing
Strength is worried about.
It was purchased I think that parts fit into the groove of the linear bush, but it was totally different commodity Once you have verified your company because the damage to extend.
Era of ignorance of human beings to buy the net, I wish us a little more clearly.
The remaining 53 pieces can not be used. (Oh, shame.)
Osaka soul brand, but because manufacturers in product photos could be confirmed, was able to buy with confidence. If you or cracking pliers hole, because it is a component that removal is difficult, but price than I look for in a quality-oriented, the price is also cheaper than other brands, was the product satisfactory. So PB, I think that if there is also that the manufacturer is changed, but I would like to disclose the information to the consumer, even a little.
The strength of the spring is the best, there is no deformation even tighten in the snap ring pliers at the time of mounting. In addition, scratch even hit it with a driving for the driver and there is a very work easy sense of security because there is a hardness that does not arrive.
When the dimension (d0, the diameter of the people of the small hole) is R-8, where it has been written and 1.2mm as measured by scanning, is like close to 1mm.
Not a personally original use, use satisfaction since the purchase in order for the experiment was to normal.