* Products that meet your criteria are shown in table below.
- 2014 TRUSCO Published Page
- Materials (magnets)
- Alnico magnet
- Adsorption Strength (N [kgf])
- Tapped-hole Processing
- 3.0 to a depth of Y in the pilot hole on the back
- Screw Holes for Mounting
- Surface Processing
- Outside Diameter x Height H (phi mm x mm)
- Weight (g)
- TRUSCO Part Number
- For alnico magnet application. Best as far as operating temperature. Adsorbability is if 20deg C is 100, it still keep 85% under 350deg C. For short spot use, up to 400deg C is possible.
- Presser for drawing, ruler, forming sheet. Screw hole on the back can be applied to a wider assembly jig. Can be used by fill in press die. Can be used to hold workpieces during wire cutting.
Customers Who Viewed This Item Also Viewed