The reviews are automatic translation.
On 2017-06-04 10:12:07
The tear of the tie rod end boots and the tear of the lower ball joint boots at the inspection were repaired. " I cleared the vehicle without problems.
On 2017-05-04 10:25:10
I chose it by price at the fusion tape itself I usually use. I think that I will continue to use it because it can be used enough.
Waterproof treatment of electric wire
On 2016-02-01 14:41:25
The nearest tool shop is old because it is old and does not become usable, but Monotaro 's are new and comfortable to use.
Termination processing of outdoor wiring
On 2015-10-21 20:02:31
easy to handle. You can usually use it like a vinyl tape.
It is used as an exterior tape of air-core coil.
On 2015-07-01 10:26:31
① The price is relatively cheap and it is good to have a place where small lot can be purchased. ② Taping workability is not so bad, but there are occasional times when the tape is not loose, but there was no problem if it was handled politely.
Non-slip clamp handle
On 2014-06-30 20:22:17
I use it to wrap around the handle and use it for nonslip, but keep them in contact with each other and stick together.
Bundle of wires
On 2013-06-13 13:44:41
Easy to use and very good
Taping of high places such as difficult place to work again
On 2013-01-08 11:39:13
About a week or so, pulled parts broke. After fusion, it is pulled, it feels like to cut. To some extent, if not tough, I will not fuse, but pulling, I can tear off later.
Water proof treatment of coaxial cable connection site
On 2011-09-18 18:00:42
In the transition of digital terrestrial broadcasting, although there were many antenna constructions, in order to reduce the burden on customers, we have diverted existing cables as much as possible. If the joint with the new line is outdoors, if the waterproofing is incomplete, construction failure will result and water leakage ~ rust generation ~ radio wave deterioration, but the connection part is fused after wrapping it while extending this tape It becomes completely waterproof. It is expensive in terms of price, but 40 to 50 cases can be constructed in one. It is perfect if you wrap an insulating tape on the finish, but the insulation tape itself has low weather resistance, so it can not be used alone.
Non-slip tool holder
On 2010-09-11 15:15:50
As a nonslip, it is so self-welding, clinging and clinging it for a long time will stick to each other and peel off. It is somewhat better if the surface becomes dirty when used. Although there is a commercially available anti-skid tape for handle, but the price is too high, I use this tape for cheap but safe.