|The pack twist drill for ironworkers
The pack twist drill for ironworkers
- for machining of Mild steel, cast iron, aluminum, copper, plastic and lumber
- Helix Angle
- Point Angle (Degree)
- High-speed-steel (HSS)
* Products that meet your criteria are shown in table below.
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
7 Customer Reviews
The reviews are automatic translation.
On 2016-08-14 19:43:45
Because it is a reliable manufacturer, all of the teeth of the drill are all in this brand. In the nearby home center, since it is not available in 0.1 mm increments, we buy it instead of the shipping fee for Monotaro san cut 3000 yen.
Iron plate drilling operation
On 2016-01-28 18:17:10
It is safe because it is a leading manufacturer
On 2013-07-11 13:19:48
NACHI which is cheaper than home center with the same manufacturer product is sharpness good! It is!
On 2012-07-25 22:57:48
Both good and bad are with thinning. It will be more helpful if you sell a cheap one who does not have thinning in a paper bag.
Used to drill a hole in a hand tap.
On 2012-07-08 00:40:55
Although I have not used it yet, the places that are rich in type (diameter) and inexpensive are very good.
Drilling into molds / products, etc.
On 2012-03-02 13:06:58
Unlike commodities of anonymous manufacturers, holding of the cutting edge is also good and hole accuracy is there so much.
Drill for helical insert
On 2012-02-21 14:55:15
Cost performance was a good product.
Customers Who Bought This Item Also Bought