The reviews are automatic translation.
Use the deburring of the finishing of the resin product
On 2017-02-09 15:36:57
It can cut without scratching the surface around by the acute angle of the blade when you remove a part of Bali you want to take in the finishing circular
On 2016-05-02 09:28:56
Classic in the classic, because earlier thin, also helpful in fine work.
Cutting the plastic
On 2016-04-14 08:40:29
We come in handy so often used in the work.
In ordinary places that do not reach the blade of the cutter you will receive if this 30 degrees acute angle blade.
Because to buy a lot, you are buying large quantities when cheap.
On 2015-12-09 11:40:09
Since we use in the paper craft, we stuck to the sharpness. Fold and I use while folded so they will sharpness. Blade is a necessity.
On 2015-11-17 15:35:39
30 degrees is easy to use in exceptional, fine cutting is almost impossible in a normal angle of the cutter.
Thin cut crucifixion the marking tape to glass
On 2015-06-25 17:12:41
In the past we use to reason. There is no sense of incongruity to otherwise use.
On 2015-03-27 09:24:36
Because the consumables will also buy it vanishes. Fine work is easy to do.
Finishing Deburring of rubber products
On 2015-03-23 13:24:47
Sharpness may be, because the sharp than normal of the cutter blade, you may hear a small turn to when you as possible, especially along the small curve and circle of R.
If you are using this, it is about feel difficult to use ordinary of the cutter blade.
For a little cut
On 2014-09-30 14:29:20
10 sheets will feel less about the number of sheets of one set.
In addition, blade and together fold the blade to the case (broken blade case and integrated ones) I think how good even.
On 2014-06-16 13:07:39
Since the tip of the blade is thin it is ideal for a fine work.