The reviews are automatic translation.
On 2017-03-24 18:06:11
The more I thought, I could not drop the rust. Or how to use that bad?
Peel off rust paint
On 2017-03-04 17:45:12
Wire will jump well, is in use, and not forget the goggles worn
It used in the rust off, such as iron
On 2016-04-21 16:55:49
The unit price, although I think that may be an affordable, I think it may be a cup brush with excellent a little more durability.
Burnt up after stainless steel welding
On 2014-11-10 22:24:33
If you are using an iron cup brush until now, made of stainless steel was in it can not be used for removing burnt because it was expensive.
The inventors of the present product was trial because it is relatively inexpensive, we decided to continue to use so very good.
Welding of deburring
On 2014-07-07 21:29:31
Is the same as other manufacturers to scattering of wire, but is satisfied because there is cheap price.
Tire iron foil Shine
On 2013-06-29 09:59:59
It is very dangerous splashing around wire while working.
Wire I have will quickly brush is no longer missing immediately,
Does not become completely useless, is the adulteration of about could lose confidence in it to sell.
Rust removing polishing work
On 2013-03-12 16:51:28
It is very dangerous omission of wire is badly splattered wire still stuck.
However, cheaper only adulteration of.
It does not become almost useless.
Stainless steel water pipe sealing tape removal
On 2012-10-07 20:25:02
I use a short stainless steel water pipe in the lathe for sealing tape removal work. Although the work itself ends in a few seconds, the omission of the wormer is severe and very dangerous. I am going to step by step because I'm awfully missing and I can not escape on average. I also stuck a lot in my work clothes. It is severe to be withdrawn from about 580 items sold at home centers. You are not inferior to Einsin which went bankrupt. Since the work was made of stainless steel material, I did not go to translate the normal wire brush, but I tried it but it was a disappointing result. Just like company Eisin that went bankrupt, "company goods" only dirty company name.
Burn off of welded part of stainless steel
On 2012-04-19 20:00:40
I am using it with a low speed grinder, but I am very satisfied with the finish without a lot of missing, I am very satisfied, I can not proceed much with use with a normal grinder
On 2011-08-23 08:25:25
It does not match Thunder's rotation. Wire falls out (scatters)