The reviews are automatic translation.
Measurement of shaft runout of milling machine
On 2017-05-01 15:15:06
It is good to be small, but weak holding power at adsorption, it moves. Also, since the holding force ON-OFF changeover switch of the magnet is too hard, the position moves when switching.
Runout adjustment of the lathe work
On 2015-12-28 16:20:05
Until now, the mini-lathe was using a standard magnetic base, but the alignment of the dial gauge was quite cumbersome.
Meanwhile, where another single magnet based in a different application is looking for will require, I purchased this flexible mini magnetic base is found.
Honest, but it seemed likely to ease-of-use than those of the up to now, I was surprised with, very happy because it set in almost one action.
Setting of machine tool workpiece
On 2014-07-08 09:29:17
There is no problem in use, but the lock part differs from the photo What is different?
Main spindle core
On 2013-03-12 18:08:16
I mentioned that the flexible part is loose with the previous review, but when tightening the middle lever, you can use the upper and lower flexible parts for tightening work without problems, I was disappointed. What principle? I guess.
Gauge attached to core squares etc. of machine tools.
On 2012-06-29 21:00:27
Since the arm is short-circuited, it is easy to measure with a small gauge marked with a small gauge in a narrow place.
For support of dial gauge for centering inspection such as coupling
On 2011-06-27 21:34:59
Since the fixation of the flexible part sweetly rotates 360 degrees and uses it, since the position of the tip is slightly displaced, the indication value of the dial gauge is not reliable and there is no value of the product ⇒ Again the made in China is cheap Can not trust? Is it useless if you choose prices and product introductory sentences? I think.
Used as fixing jig for sinker
On 2011-05-27 04:05:01
Although the product size is very satisfied, I am concerned about the weakness of fixing the magnetic force and the flexible. However, this size at other manufacturers is personally saved because the amount of money changes a little.
On 2009-06-12 20:59:13
If you purchase it and start using it recently, the root is loose and I would like you to exchange it. The two previous products can be used without problems.
Fan, main spindle of pump and used for adjustment
On 2009-03-25 19:09:12
I think that it is good to be satisfied with the price, and improve the point of completely fixing the flexible part a little more.
The core of the coupling
On 2007-10-18 08:48:13
It can not be fixed unless it is tightened strongly. It can be locked with something like a small lever, even better.