The reviews are automatic translation.
On 2016-11-01 19:30:59
It is cheap because it is cheaper than other companies' products. If it is expensive, it will be replaced after using it to the last minute, but if it gets a little motion can be replaced easily if it becomes bad. I do not yet understand the durability, but I expect it
On 2016-03-15 15:47:23
On 2016-03-09 20:28:40
On 2015-12-19 20:03:14
The price is also cheap, I use it without problems.
I exchanged the wheel bearings of the motorcycle.
On 2015-12-14 20:36:34
Since balancing of the rim is not over, I can not say anything, but I am sure I am satisfied.
On 2015-07-16 09:19:15
Because it is cheap, strong and cheaper than a pulley.
For replacing the motor bearings of the press machine.
On 2015-03-29 21:08:29
I just had to replace it, I'm looking forward to having it for years.
It is a repair part of the tool.
On 2015-01-21 23:25:42
There is no problem with that. Especially, this 6304 is large, domestically produced bearings will cost more than ¥ 300 per piece. Even cheap, OK, we will continue to use it.
Finish after welding
On 2014-12-11 17:41:05
It is cheap and easy to use.
Fabrication of metal roller conveyor with 2-piece bearing set
On 2014-10-24 19:06:05
The pipe outer diameter 38.1 is an inner diameter of 35, and a bearing with an outer diameter of 35 is put in it and a roller is made with the thread cutting rod as the shaft. We made several conveyors. It was incredibly inexpensive.