The reviews are automatic translation.
Use for cutting wood and pipes
On 2018-06-04 22:02:50
It is cheap and you can use it for Makita and other manufacturers in general purpose.
Even if you mix not only one type but the difference of counts, selling is good,
By coarse, intermediate, finish cut material.
On 2018-02-01 18:42:56
Cheap = good common sense is not good quality parts It is also good processing accuracy and finish Anyway it is pleasant to cut
Cutting of metal parts
On 2017-04-12 16:31:33
Since there is no hole, you can feel secure and you can fix it to a jigsaw and work safely.
Cheap and satisfying ♪
On 2016-10-19 20:36:14
Aluminum stripe plate t 3.0 and steel plate t 3.0 were cut without difficulty. Both had a total cut length of about 1100 mm, but without cutting the sharpness without changing the blade until the end. The edge may have been rounded at the end.
To peel off the steel cutting slab stuck with oil
On 2016-05-15 22:35:39
It is cheap and good
On 2015-10-05 14:38:04
Replacement blade of expendable supplies Ordinary superiority !!
Unit bus construction
On 2015-04-08 21:57:37
With unit bus construction, we were able to work without stress when processing steel panel wall panels. There is no burr and there is no problem on the cut surface. From next time, this is a rule.
Iron plate cutting etc.
On 2015-01-29 08:47:14
Considering it as a consumable item, I think that there is no loss. We can use it enough, so I will continue to use it.
Iron door processing
On 2014-07-19 13:42:53
It was purchased a second time because it was usable without problems.
Processing of steel plates
On 2014-06-07 19:11:01
The first 5.6 times went smoothly.