The reviews are automatic translation.
On 2017-09-11 16:01:15
Just a good size. The nozzle length is also just right.
For oil change
On 2017-08-24 19:51:38
I think that it is good because it is structured to prevent dust infiltration during storage.
Also, the threaded cap at the nozzle tip can be attached to the upper lid when lubricating the car. I feel that the nozzle is a little hard.
On 2017-07-14 08:53:54
The lid of the lid is bad, it is the same as without a lid which is hard to settle
To replace grease in automobiles!
On 2017-07-05 16:04:01
Since it is possible to cover the lid of the nozzle tip and the mug itself as well, it is convenient to think that being able to prevent dust mixing after use is convenient! The price is also cheap and is fine.
When car maintenance
On 2017-06-11 17:48:17
I bought it for exchange of coolant liquid. Since it can be sealed with a lid, it is handy for storage.
On 2017-06-08 08:57:57
Purchased for use in gear oil exchange of tiller. I think that it is good that the nozzle also has a long lid so that dust does not enter. The price is also cheap and good, but the gear oil mouth is in the lower person, the tire is also there and it is narrow so I thought that the nozzle was longer than 2 cm ~ 3 cm longer.
Car oil change
On 2017-05-16 22:00:22
When delivering Since the nozzle was packed by being pressed along the body bottle at the position of 90 degrees just below, a large force is applied to the nozzle peripheral parts and the parts are damaged. When looking at other product review posts, nozzle peripheral parts broken, broken, etc. Is it also caused? Remove the nozzle and fix it with the masking tape inside the main body or remove the nozzle from the opposite side of the plastic screw and install the plastic screw and the nozzle will enter the inside of the main body so you should pack it in that state. Please improve the packaging method. I personally want it because there is no leak tight cap at the tip of the nozzle looking at the product. I think that the nozzle is a little thin for 4L. A little thicker will be saved when oil is introduced. Since I have not used it yet, I will re-post it after using it several times.
It is used for repair etc.
On 2017-04-24 15:19:45
It was nice to buy it very easy to use. I am very satisfied.
As a mug when changing oil
On 2017-03-13 15:16:40
You can make a lid where you put the oil in the jug, and the tip of the pouring spout is also very convenient, like a plastic bottle with a screw type cap.It is recommended.
Engine oil change
On 2017-03-02 20:19:51
With lid, since dust does not enter, it is safe. The nozzle cap sticks to the lid, so it is well thought out. If there is a long nozzle separately, I think that it is the best in the oil mug.