Oil Pump, Change Master Mini
* Products that meet your criteria are shown in table below.
- Engine Rotation Speed (min-1[r.p.m])
- Compatible Viscosity (mm2/s)
- 1000 or less
- Intake DisCharge Port Diameter (mm)
- 20 [3/4 Inches]
- Engine Voltage (V)
- Engine Output (W)
- Power Cord (m)
- Maximum Discharge Pressure (MPa)
- Connection Screws
- For parallel screws
- Maximum Delivery (l/min)
- 20 Minutes
- Current (A)
- Weight (ｋg)
- TRUSCO Part Number
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
2 Customer Reviews
The reviews are automatic translation.
Exchange of the reduction gear lubricant
On 2015-09-27 20:34:43
It is cost-effective outstanding. Speed reducer 39 single oil change. We used to oil change of the speed reducer of 1.2 ~ 20L. I was sucked from the filler neck, but the IN side of the hose according to the filler neck I used while replaced with an inner diameter of 8 ~ 12mm. But when the diameter is small now work while rest in consideration of the heating condition of the pump, I have finished the work process of the six days in three days.
It was purchased for use in the hydraulic oil replacement of the hydraulic system.
We are using assembled a self-made hose rather than the manufacturer's recommended hose set.
On 2010-03-27 08:41:54
Point where the work from the put call oil pump is a bit cumbersome.
It is non-returnable commodity, but are out of the mounting of the motor frame and the pump part, because the state is not stable on the floor surface that would have been forced to use via a rubber damper under the frame is dissatisfied point.