The reviews are automatic translation.
On 2017-05-19 19:34:37
In the factory, work
On 2016-09-29 19:26:49
Lightweight and was also a sufficient strength of the adjustment and the maximum value of the AIR amount.
On 2016-08-03 02:52:36
It was a little different as I thought.
The impression compared to resin duster TD-100 of Torasuko, but feel seen in the photos you cool dark gray, in fact, cheesy in reverse too light.
In addition, in the use of surface, it does not feel the pull cost less gripping much of the lever. Since between the portion grip the lever does not enter the small finger, (it can not be better grip to apply only the index finger to the lever like a gun) which is limited is how to hold. Also, do not be caught and not the one of a thin plate-like as you Hikkakeyo the duster caught something during this time.
I the less pull margin of the lever was quite disappointing, but this is probably to adjust at a flow rate adjustment dial, it feels like it is assumed how to use that to always fully open the set amount at the lever.
In addition, the outlet is because the external thread, low versatility not use the hand instead of opening.
In people who do not become a problem that was mentioned above, there may be a good product if seek lightness, personally rather than a feature for this lightness is lighter, less expensive products that reduce costs has received such an impression as (yet actual price is bad cost performance because almost the same price as the resin duster that uses a metal)
Interior tool cleaning, work clothes of dust removing
On 2016-06-08 20:08:04
I thought likely to come in handy in a powerful than. It is a point that the air leakage from the connection After the increase the difficulty. Just because pointing able to re if can eliminate to much become a care or.
Use in precision machining
On 2016-04-06 21:01:17
Metal air duster at the contact of the workpiece This product too is large damage is a plastic damage is small
it's recommended. That would like to ask the future in this product would like to ask a wide-angle adjust the air volume in the nozzle at the trigger. In particular trigger part grip hand would like to ask the subtle volume adjustment.
As air duster
On 2016-03-24 15:27:40
Light durable though. And cheap. Trigger is also easy to use big. Good can flow rate adjustment. When the maximum, it to, it will be saved because it is weak when you blow off the dust of delicate components out pretty air. You can adjust the flow rate in the grip how, but work efficiency goes up because it so as not to leave only a certain amount even if full grasp.
Water droplets such as removal after car wash
On 2015-12-15 14:54:04
For all in the lightweight plastic, hard to scratch the car. Also, rust is not.
Cleaning of manufacturing equipment
On 2015-09-19 09:41:02
Lightly, even if I by any chance fall is almost never be damaged.
Unknown about the durability of moving parts
Air blow work
On 2015-03-13 14:57:29
Try actually have, I was surprised by the lightness.
One-touch plug portion is also the plastic to be connected to the air hose, but that was a little anxiety,
Without such as air leakage was worried, you can use without any problems.
If there is a drawback,
Screw of the nozzle section, rather than a general taper screw in the pneumatic equipment,
Although much is that it is M14,
The company's resin-made long nozzle (TLN-140) is You can use it,
Inexpensively because is like can be converted to G (PF) 1/4 female thread with an optional adapter (AD-1/4),
I felt that it is not the big problem.
I think that it is good value, if this in thousands of yen.
Cleaning work in the air blow +
On 2013-12-13 13:15:38
Body is not tired even in lightly long hours of work.