The reviews are automatic translation.
3 mm tap pilot hole
On 2017-10-31 20:18:09
I bought it for 3 mm pilot hole,
Whether the core is blurred, it becomes a hole close to 3 mm.
Measured with a caliper is 2.5 perfectly, but I tried about 5,
I dispose of it because they are all the same and not usable.
Just to be sure, we compared it with other Kiri destinations that I have,
After all it is just strange here.
I am using it to make holes in steel.
On 2017-05-31 00:24:06
It may be that there is some strength. Whether this is bad is pretty, it breaks. It might be good even if a sticky material is used.
On 2017-04-23 11:14:47
I am dissatisfied with durability which is easy to break compared to other products. Even if you use drilling oil, it tends not to cut. It seems to be suitable for DIY. As a professional tool it is recommended that about 2 millimeters of iron is used.
Plastic hole drilling
On 2017-04-21 18:21:59
I think that it is very cheap. It is used in multi-axis drilling machine. It is a feeling I gained.
Control panel installation
On 2017-04-17 18:11:25
Although I use only two out of ten, one will shift the center even if using a punch.
During construction work
On 2017-04-02 14:46:27
As it is still a consumable item, it is nothing more than cheap to use.
Purchase for M4 tapped hole
On 2017-03-02 21:13:25
Because the price is also cheap, I chose to disposable rather than regrinding the tip, but since I do not strike the punch, the tip of the drill is a bit broad, so if you use it as it is with an electric drill, it is not fixed to the position I want to open, so the tip a little more I would like you to be sharp
On 2017-02-21 21:17:04
Although I do not use it much yet, cost performance is good, but durability is not good.
On 2017-01-30 13:54:07
I purchase it every time. Because quality is low price without problems, we are continuing to purchase.
When opening a bolt hole
On 2017-01-26 17:06:30
I bought while worried because the price is quite cheap with other companies, but sharpness was good and easy to use