Buy more than* S$200* and get FREE SHIPPING
Due to the national holidays as Golden Week, we will close 2018/4/28~2018/4/30 and 2018/5/3~2018/5/6.
This may cause delays with our responses. Thank you for your understanding.
I arrived on January 4th. I tried to work with saying the beginning of the year, but for the adjustment of the fixing screw of the clip part, once loosened, the base of the clip where it was tightened became Peshanco and it can no longer be adjusted. Other adjustment screws also moved poorly, so we stopped working in 15 minutes as fixing is hard to do. Of course, only with fixed work. I think that I have to think about the entire deal with Monotaro.
I intended to fix the printed board and use it for soldering, but the finish of the ball part of the joint is bad and you can not use it unless you tighten the thumbscrews each time you change the angle. Even when tightening the thumbscrews it is hard to operate on the verge of interfering with other parts. Do you use it as a paperweight?