The reviews are automatic translation.
When super finished canna blade is adjusted
On 2017-04-30 22:14:40
The magnet part is very stable and easy to use. Since the object to be measured is 30 to 40 microns, it is understood that precision does not occur in fine feed, and it is currently in use by removing fine feed. If there is description of the limit of fine movement feed in the product introduction column I think that I bought a base with no wasteful fine movement.
Mounting of the dial gauge
On 2015-10-25 21:19:19
It is good to be able to select a shaft.
The choice of length.
Out swing of lathe work
On 2015-10-23 14:40:30
Part of fine-tuning the strength is weak, could not use decent. It was replaced in addition to the round bar that was there in the factory.
Mounted use in mounting machine of dial gauge
On 2015-04-10 13:50:33
Satisfaction at a low price. Speaking of greed magnet base of the suction force feel weak.
I wore a dial gauge
On 2015-03-26 18:31:07
Fine movement Feed is very convenient. Without there is a big difference.
On 2015-03-09 10:06:09
However, it has been used in mounting the Pikkutesuta, fine movement feed useless too.
You may want to use think about can be used in the adjustment level of roughly.
Measurement work of the shaft such
On 2014-12-19 00:22:49
Magnet is slightly weak feel that. Rigidity feeling of the arm also weak feel that. Main struts, also tighten to strengthen, so soon loosen, screw lock need
Sensor fixed at the time of test
On 2014-09-16 14:19:55
Rigidity is also easy to use if you are firm.
Tasks such as milling machine
On 2014-02-12 22:15:07
I think grateful if there is a little more strength.
I hope a little more there is also a degree of freedom of the movable.
Of product runout inspection.
On 2013-07-29 08:06:40
Magnet also can measure that was stable and strong, also, because the easy fine-tuning can also shake of product inspection and is very useful, for example, the machine set-up.