The reviews are automatic translation.
I am using it at the time of hand work such as stained glass.
On 2016-05-26 16:58:54
I have enough illumination, magnifying glass is very convenient for detailed work. I am satisfied with my work satisfactorily.
Fabrication of accessories
On 2014-11-23 14:18:51
The other day, the switch broke and bought a new one! I have been using it for about 8 years on the second machine, but COSPA does not have any problem.
When inspecting the product (metal pipe) in the factory
On 2014-11-21 13:42:37
It is easy to find very small scratches with magnifying glass and fluorescent lamp. The point which can be adjusted with an angle which is easy to use is also easy to use, and it is popular from the field.
Lighting and magnified observation of lathe milling operation
On 2014-02-12 22:09:17
I am happy that it's a bit cheaper
Repair work of precision printed circuit board etc.
On 2013-10-10 12:02:11
Usability is good. There is no problem with accuracy with glass lens. There is sufficient illuminance. It suffices if there is an LED type of the same illuminance.
On 2013-02-13 14:34:18
It looks very good. It is better if general-purpose HF fluorescent lamp bulb can be used
On 2012-01-20 05:29:09
I can not tighten the moving part, I will bow. A level that can be disassembled, improved, and used.
Check for reduced print and use for reading
On 2009-06-16 15:11:53
There is a ring-shaped small distortion around the center of the lens and it becomes matter of concern. Because it is a low price it will be this level of lens. Still it is just good to read books of small letters with presbyopia. Those who are thinking about using in precision work should pay attention.
On 2009-05-03 20:37:00
I am satisfied that I can buy it at half price of woodworking and engraving specialized catalog. There is no problem in the brightness and magnitude of the magnifying glass. When moving a machine with vibration, there are times when the spring resonates and the sound comes out, but it can not be helped · · ·
On 2008-11-14 13:28:43
Fine adjustment of the fixing knob is subtle. I can not stop even if it is loose even slightly, I can not fine-tune it even a little. Although the movable parts are in contact with each other by metal, I think that it can be adjusted somewhat even in a state where it is caught by a resin washer or even if it is squeezed. Is it a range to devise by yourself from the price?