Buy more than* S$200* and get FREE SHIPPING

Hand Lap, Glass, Pump Dispenser

2.67 (6)
Material (pump part)
Brass , nickel plating
AS ONE Part Number
1-4612-01
Material (Tubes)
Fluoro-resin (PFA)
Material (cover)
PP (polypropylene)
Overall Height (mm)
108
Diameter (phi mm)
85
Material (Body)
Soda glass
Capacity (mL)
170
...see all
Product Options
ADD TO CART
Package
Qty.
Ship pack of Mfr.# Item.# Sales Price Availability Qty.
Package
Qty.
Ship pack of Mfr.# Item.# Sales Price Availability Qty.
1PC 1 200 09155124 15.76 SGD
In stock
ADD TO CART
Customer Reviews
5 star 1
4 star 2
3 star 0
2 star 0
1 star 3
Review Rating: 2.67
6 Customer Reviews
The reviews are automatic translation.
Degreasing work (gasoline use)
1
From Japan
On 2017-03-10 21:52:30
I it is sufficient to stop at the first "click" outside cap is turned to the two-stage, but will be helluva not take and would fit all the way. To remove It must be withdrawn brute force and prepared to spill the contents. Less "usable amount of liquid" in due tube length is short, and the restless It must be added together poured. Since usability is bad another product to enter the order of 300CC I use to buy.
This review is about item#9155124.
For the cleaning of the electronic substrate
4
From Japan
On 2016-11-03 18:56:19
We are using put the anhydrous ethanol, but Ki can be used without problems It is very convenient. Cap will enter and a pop but it also felt like a little stiff.
This review is about item#9155124.
Removal of solvent for wiping operation
4
From Japan
On 2013-12-26 16:16:38
Mostly satisfactory. Originally, when trying to remove the outer cap from the bottle, the catch with the bottle body was too large, it was very difficult to remove. I wanted to improve this point because it was just fine as it scraped off the bulge inside the outer cap with a cutter knife. The inner tube does not reach the bottom of the bottle has design intent and is meaningful and does it? I want to be improved if it is just a design mistake.
This review is about item#09155124.
Cleaning before printing.
1
From Japan
On 2011-08-23 22:00:29
When putting benzine, the resin part will crack a few days later and it will not be used. Because it is impossible to return it, it can not be done either.
When cleaning alcohol
5
From Japan
On 2010-11-19 11:07:43
It is convenient because you can use both hands. Although I was a bit uneasy looking at the review, I can use it without problems.
Used for solvents such as printed circuit board flux removal solution
1
From Japan
On 2010-08-29 02:37:11
The tube is short (it does not reach the bottom), and it can not be sucked if the liquid volume is low. I want the cap to be screw type. If the inner cap is loose, liquid is scattered when removing the cap. Inner cap is easy to loosen. After purchasing one, I purchased two additional, but one of the latter two, the inner cap quickly loosens, one is that the inner cap screws are stupid and can not be used, after all the second two Not available.
This review is about item#09155124.

Related Products