The reviews are automatic translation.
Scale is fixed? !
On 2016-07-21 18:05:44
0.01mm dial gauge, but some have also been used, for the first time is that scale does not rotate! Since most of the person is not saying anything, whether this is of a commonplace in the 0.001mm gauge? , Or is this just the is defective, does Mase Hontowakari. In answer to the person of the same I think, but we're saying that there is no need to adjust the zero point in the gauge, the much-to-Tsu out zero, not there the first time the scale meaning of the combined reference point to 0 whether.
On 2016-03-09 20:59:21
Tasks such as milling machine
On 2014-02-12 22:13:23
You may not be able to work with the press a little.
And except for it are satisfied.
Milling machine work
On 2013-12-17 08:21:18
Minute hand has directed in the direction of 10 o'clock for the first time out of the state from the bag, the hour hand is swung to the negative direction. That is the origin about 0.04mm is offset in the negative direction. For this reason, when rotated more than one round the hour hand must subtracting this offset is very usability deteriorates.
Since the first time I purchased a dial gauge of whether "such a thing" that's either a defective product of judgment does not stick. Not good people of mental arithmetic is to be careful not to buy.
On 2012-12-11 11:59:15
It was necessary to attach the ear gold, but it was not included. I will use it from the old one. Since I am satisfied with the price, I will order again, but please confirm.
It is purchased for the crankshaft of the motorcycle
On 2012-05-08 10:46:56
It's easy to use, and the price is also cheap and it is a very good product. If you raise it strongly, since the measurement stick is short, I think that it is difficult to measure depending on measurement points
On 2012-04-04 20:53:17
It is reasonably good. Because it is made in China, is it such a thing? Absolute accuracy is unpleasant, but enough to seize the trend. Case is big and complicated. Because it is made in China it can not be helped.
I bought it for the centering of the radio control helicopter. I did not need the precision here, but I bought it because the price was cheap. I was worried because the price was too cheap, but it was a bargain without problems. Since the bending of the shaft can also be checked, it is not necessary to purchase extra parts.
On 2011-05-13 13:20:58
It's easy to use, nothing special.
It is used to measure the amount of movement when moving the core turret of the lathe.
On 2011-03-10 12:41:46
Even though the price is cheap, it can measure well. Repeatability of one thousandth is also good. I am satisfied.
Crankshaft centering of 2 cycle engine
On 2010-11-25 12:23:03
It is good for price