The reviews are automatic translation.
Soldering and printed circuit board (own free) in the electronic tools electronic components, etc.
On 2015-11-28 03:27:19
Size basis also to soldering iron of goot, whether not come out is a problem in many places, such as thermal conductivity, but before and after the purchase was a worry, there was no problem at all.
Three selfish, you can use without still a problem in the first run.
Depending on the soldering iron of goot, but durability even if the trowel if the sky grilled before and after 30W is also high, the portion of the tip and use the tip for the repair agent will return to much closer to the new.
Therefore, we use normally more than a year still the first run.
Or it will have much to use up three you have purchased? ?
Prototype of small hydraulic power controller, fabrication of experimental equipment etc.
On 2014-05-21 15:29:58
I was able to exchange it correctly promptly.
Soldering of printed circuit board
On 2014-01-23 11:24:00
I am using it for soldering iron of other company's products, but it does not change as a genuine product without problems. Because it is MonotaRO product, it is appealing even in that it can purchase up to 15% OFF. If the tip is getting sore this time, it probably will be bought together. A better point than genuine is that the thickness of the soldering iron is about 0.5 to 1.0 mm thinner, it is a point that thermal adhesion with heat cover pipe can be prevented by thermal expansion. I've always exchanged small buds and heat cover pipes together, but with this it is not necessary to replace the heat cover pipes one by one. The cause of heat-wearing is that the genuine tip is ceramic-coated and the thickness is increased, the gap between the heat cover pipe is 0.3 mm or less, and the thermal expansion of the genuine tip is thicker .
Electronic board soldering work
On 2011-12-24 20:42:06
Again the new item is melting solder, adhesion is good at all, if you exchange early, quick work will last. I will continue to purchase.