The reviews are automatic translation.
Used for detergents other than water and oil
On 2017-05-09 15:07:26
There was no problem if it was water or oil, but detergent is too high concentration and difficult to raise, it took a very long time and returned to manual type.
Dispensing Kerosene to 18 L Polytank
On 2016-11-27 13:21:01
It is too broken. While doing agricultural equipment shop, we are handling a lot of products of Mr. Engineer such as pumping pump, high pressure pump etc. Whether it was this manufacturer or not, when I used the things purchased at the home center last year, the fuse blown out of the pump sounds in 1 year and a half. No matter how many times you replace the fuse. Rarely thought that I bought a defective item, but this time I bought it on this site, but it broke in 1 year and 3 months. It was a substitute that I could not think of the product of the top manufacturer's engineering. I will never buy it again.
Lubricating kerosene from drum can
On 2016-10-22 08:38:33
Performance is very good, but durability is too low. 【About 600 drum drums! Easy to use lubrication】 It seems that it is easy to use, but here one is broken down by about 5 drums, another one breaks down by about 8 and it is very disappointing .
For kerosene drums
On 2016-08-12 21:28:23
It is convenient because it can be stopped anew by electric power.
Put diesel into fuel tank of farm equipment
On 2016-05-11 20:55:54
I use it to put light oil of drum can into tractor. Until now I put it in a poly tank and put it through the filler neck. Because it is electrically powered it is very comfortable because it can be put directly from gun of Rakuoto.
Pumping up kerosene
On 2016-04-04 11:32:59
It is convenient for pumping up kerosene and the work goes smoothly
Transfer of kerosene from drum to poly tank
On 2016-01-31 15:35:40
It is the second breakdown in four years of purchase. It is actually inefficient to detach it from the drum and dry it for every use as per the reviews of other people. Now that kerosene cheapened, it is a calculation that bought kerosene with litter 10 yen higher when paying for a repair cost by malfunction every two years. Of course, manufacturers should have many repair requests due to malfunctions. We look forward to better products unique to pump manufacturers.
Relocation from fuel tank to fuel tank
On 2015-12-23 17:33:55
I want you to make the diameter of pump part (tip) a little smaller. It is not possible to use a small slot with a lot of slot.
On 2015-11-29 13:59:54
Purchase history Since it is about to disappear it is a little two years, but it is necessary for the second drum Drums are shifted to poli every time about every time Fuses fly Nowadays drums burned with 4 or 5 burning smells It did not go up and became par. It is not too early though it is not used. It is a car compressor / pump shop engineering. Please tell me if there is any countermeasure. I will purchase again but I am awful. As for the replacement for the pump, I do not know how far it is attached unless you have the photo up. I think that I did not know well.
Lubrication from drum can to generator
On 2015-10-23 18:20:56
Used when refueling light oil (about 70 liters) from a drum can to a generator. Until now, I was feeding with a hand drum drum pump, but I had to adjust the flow rate at the hand speed. Rakuaut is a fueling gun that allows you to adjust the flow rate, and it is easy to auto as the name suggests. I think what it is like to be durable afterwards, but do you have a reasonable price for the price?