The reviews are automatic translation.
For replenishing the oil of the floor jack
On 2017-05-24 12:36:37
I could also hold the contents in the state that the oil was put in, and I was able to work comfortably. ※ The tip of this product was not open. It seems to use it after cutting it so that it becomes the hole of preference before use.
Add adhesive and use it for resin adhesion
On 2015-12-09 13:37:40
Container part like bellows. I wanted a dent.
Extraction of brake fluid, for adjustment of proper amount
On 2015-06-06 13:02:26
I used it for brake fluid control on the master cylinder side. I did not know that the hole was not opened in the nozzle's mouth, I was suffering from Scosco. It is necessary to use after cutting off the mouth. With a small syringe, only a small amount of adjustment can be done, but since it is a fairly large suction amount, it was completed in 1 time. Even when returning, the hardness of the bottle was moderate, and a minute amount of adjustment was possible. I was concerned about the sagging of the nozzle and treated it carefully, but I could not use it much, so I could use it without Tarrel. Cost performance is good.
Used as a subdivision of the maintenance kit.
On 2014-03-24 13:59:54
The hardness is moderate, and it is good not to spill even if lying sideways. I do not have a cap, but the cap of this bottle is cut into soup and it does not make much sense, so I think this product is enough.
For liquid transfer
On 2012-03-21 18:29:27
When trying to suck up the reagent, it is impossible due to a molding defect at the bottle tip, it is unreasonable to break open the hole with a cutter Other than that it does not hurt to use
Subdivision of paint
On 2011-06-14 00:26:03
Because thinner will not lose, I think that it can be used for every use. It would be nice if there was a cap ....