The reviews are automatic translation.
Steel plate cutting
On 2017-10-08 11:34:38
Everything is scarcely cut out and it's awesome. Even after cutting iron, wood can be removed as usual. It is convinced that if you use this blade you sing that you can not use other blades.
Shredding waste materials
On 2017-08-29 09:00:47
Even wood with nails can cut without stopping.
Sharpness is no problem.
On 2017-07-06 09:01:08
Even wood stuck with nails is spared, and the blade is not lost, it is saved.
Cutting of Kazuno
On 2016-09-29 18:04:30
When I used it for the first time, the chip was put on. It is ok to use it so as not to put too much load. I think that you need a little technique to use it.
Wood and thin aluminum material
On 2015-12-06 17:47:50
I have not used it once but the thin aluminum has also gone.
On 2015-03-13 17:14:43
I used it to cut things that may contain nails. Even when hitting a nail, it could be cut smoothly without any resistance. I have not fully used it yet, but it is a good feeling for now.
Flow linking at the time of renovation "Cutting walls etc.
On 2014-12-22 09:00:34
When cutting only the wood, the saw dedicated to wood is far better than the saw. However, if there is a possibility of cutting a nail etc together with wood by renovation etc., work can be promoted because it can cut without worrying about it. I would like to purchase again if durability is good.
Cutting support pillars etc. at the time of partition assembly
On 2014-08-26 13:52:37
The sharpness is also good, and I feel that the sound at the time of cutting is a little quiet. We will continue to purchase if there is no problem using it for a while.
Aluminum angle cutting
On 2013-04-18 16:26:23
Although it starts cutting it, the chip is missing for the third and fourth times. If you lack one time it will not be useful at all starting to lose one after another. It is a product that will not be usable only cheap.
Cut of golf club, carbon shaft, steel shaft
On 2013-04-15 14:50:29
Up to now I had cut with 1.0 MM of the cutting wheel, but the carbon powder at the time of cutting was terribly wavy cut surface. Purchased on this trial, with a sharp sharpness, pulverized at all, touched and cut as it was and cut off. It looks like she's knocking in tofu. Tip side, bat side There is absolutely no hanging, powder does not go out and it is the highest.