Woodworking, drilling to the control panel
On 2015-08-28 10:31:18
I'm using it again to buy many years. In the woodworking for drilling on the market
This is one 択. I tried various also to other
It drilled a large hole, in terms of being firm
Better than this product is not in the other.
A problem, since the width of this freely itself is large in a narrow place
Order to get in the way, and are used cut off their own are forced end.
The thickness to be at least a hole Speaking greed is that I want you to more than 10 centimeters.
It Although's the number that you want to open the roughly 10 centimeter close the through-hole
Because it does not reach, open half from one side, is passed through the center hole with a bit on the other side,
I feel that the drilling taking the same center from the back side.
When you open the structure because it is, that this freely of width is large,
(Also by narrowing the width width is wide remain such because) and (but can I cut),
The maximum value of the drilling is that it is normal.
And tools such as not only opened the diameter of the other of a few centimeters
It is not a special that point because it does not open only the depth of the same degree.
It has a solid, and has a diameter in comparison to other products
It is selling up to that larger is opened.
Then, this product is impact Tsukazu,
Not attached only to the large-scale professional tool.
Therefore, because it is multiplied by the firm torque
However, since we Womotte tips in craftsmen to make a hole in the control panel
Please consult to work after the close attention towards the amateur.
More specifically and control panel, when you try to open a hole in the tree, such as a section
(Especially when there is a large drill a hole of diameter), but is especially so When the blade is been a little degradation
It caught in a tree. Sonaruto not turn the drill unreasonable,
Tilt the drill to the right and left turns if off bit by bit.
Also in the sense that there is no product that can compete with other comprehensively
Not without is a commodity. I feel that it is generally excellent.
Durability is also high.
On 2012-02-08 21:29:59
Had been used up to now is the balance had been or tung of the adjustment screw is loose scary or bounce or a round hole becomes larger think when processing work bad, but this is easily it can size adjustment width adjustment handle of Kiri is also safe because it fixed the big firmly. Also it is is very good even better blur there is no feeling of use the balance of the total. Is somewhat higher than the others, but is nice to be used with confidence is better here