The reviews are automatic translation.
Waterproof treatment of cable tip
On 2018-03-24 00:18:44
Because I do not have a dryer, I handle it with a lighter. It seems that there is no problem as it contracts normally. The finish was more rigid than I thought. I think that it is more harsh than the situation assumed usually because it is a part that touches the seawater, but it seems that there is not a problem at the moment. I do not know to what extent you will bring it in the future.
On 2018-01-05 15:19:46
I was drowning during work, so I suddenly suffered from a lighter who was in Pockets, but it was a correct answer. I tried using a dryer later, but it did not contract too much.
Used for maintenance of CELLO 225 W
On 2017-11-15 08:36:27
Sometimes the fuse blown, so I arranged the wiring. I think that it is necessary and sufficient quality.
With extension of sensor of temperature controller
On 2017-07-01 18:57:16
I extended the cord of the temperature sensor used in the steam atmosphere and used it for the soldered part, but it was indeed a good condition.
"Heating with a dryer" is written, but it is irritating at home dryers first. When will it shrink ... the sun will fall.
It will be completed quickly by heating it like feeling it in the flame of a disposable lighter.
However, it is necessary to do quickly so as not to melt the wire covering, and burns need attention.
On 2013-06-26 13:08:51
It was thicker than I thought, and it contracted when it contracted. I was imagining a more supple finish, so it was a little surprising, but there is no problem in protecting the wiring part. There is a sense of security as the inner glue melts with heat and comes in close contact.
On 2013-03-20 21:07:44
In the dryer on hand, the thermostat worked before it contracted with heat, so it was shrunk with the lighter and it was shrunk, but it was able to be used without problems in particular. It seems that the inside melts and comes into close contact with contraction at the same time.
On 2013-03-11 13:49:37