The reviews are automatic translation.
Cut of PE hose
On 2016-06-22 15:31:20
We used to cut the hose to inject the resin, but I really helped us because the cut and sputtering with a light force
On 2015-12-04 11:15:09
Kana is suitable to buy a small diameter for the tube cutter
Purchase to make a spacer
On 2015-10-04 15:57:47
Buy did that with the cut at a right angle, I Is not it 90 degrees to the right angle
Everything is diagonally cut so that the blade is run away.
It is finally put to place the monitor and angle the stick, but three times to make one is to waste.
It was Mayutsuba before you buy, but can now be used to remodel after all.
Probably I think that it is perpendicular to mock you are saying everyone in other cutter.
Guess Is not it a problem writing a right angle?
On 2014-11-17 13:03:05
Soft tube, such as a silicon tube (12/16 mm) is you will end up with the cut surface is slightly uneven not turn off slowly.
Other plastic tube (16 mm) and air tube (6 mm) can also safe connection of Pisco because the cut and flatly.
Also convenient to what mind measure also has been hidden in the rear of one meter.
You have to cut the rubber, but of 11mm in a short length
On 2014-10-13 14:11:23
Cut feeling pretty good condition.
There is no waste because the cut straight flat.
Removal I thought Naa convenient or when there is a guide that can be easy Speaking greed.
On 2014-03-13 18:23:12
Easy to handle cross-section is also beautiful.
Cut of the air tube
On 2014-03-12 15:58:53
The cutting operation of the air tube until now, but which had been carried out in the usual cutter,
Work efficiency went up from to buy the item.
Since it is a type as possible on both sides, or bend the tube, the cutter mat under
It will expire without drawn.
In addition, it is unnecessary shuffles since the cross-section is clean.
I will try also recommended for people around in the future.
Maintaining compatible device using an air cylinder
On 2013-01-25 11:42:30
Order to cut clean, peace of mind without air leakage from the joint of the cylinder.
Used to cut the 1/4 tube vertically.
On 2012-02-23 15:22:03
Because it is new, of course sharpness is good. Speaking of flame, whether the button of the locking portion is caught, do we place a little hard to miss.
Cut of literally tube.
On 2011-01-27 00:56:05
Because it was not in the neighborhood of the hardware store, buy mail order. Even once cross section survives it can be cut to the beautiful peak tube. After the purchase, it is mortifying had started selling in a more low-cost in the neighborhood of the home center.