The reviews are automatic translation.
When examining the presence or absence of the gap.
On 2016-06-10 15:22:56
Since consumables, it has survived cheap.
Gap adjustment of the drive pulley of the 3D printer
On 2016-05-03 01:16:47
Thin even though I was able to eliminate if you are very firm easily the gap between the pulley and the shaft.
Pulley of the center-out can be done easily.
Mold guidance of overseas
On 2016-04-03 09:34:56
We used to very useful as guidance at the time of the article.
Cheap and satisfaction
On 2015-07-12 11:21:28
Although we used a third-party product, you buy to try cheaper who Monotarou product with the same specifications. Third-party products and inferiority, not to repeat the order we so cheap and very survive even one yen because it is consumable!
Also to everyone it is recommended.
Use the auxiliary set against work
On 2015-06-23 02:27:06
Except that the case was difficult to open tight and, satisfied with the feeling of use
Headstock adjustment of the lathe
On 2014-02-24 20:12:13
It was used in the headstock of the center out.
Normally use cost performance is amazing
Besides we also use it as a thickness gauge.
On 2013-10-02 17:09:33
Monotarou's filler tape is made of easy-to-use price is reasonable. I think very good. Purchased from the previous, we use on an ongoing basis.
To measure the gap between the dental tooth.
On 2013-09-13 13:13:37
The auction condition of teeth and adjust using this gauge. The hope, I want a soft material such as a film, not a good enough but metal can leave now. If that happens I think that increasing the frequency of use more.
It uses as a gap gauge
On 2013-06-05 15:17:19
There is no problem to work.
Durability is weak.
On 2013-06-05 15:10:32
There is no trouble to work.
Durability is not much.