The reviews are automatic translation.
Chamfering of the hole
On 2014-06-17 10:39:34
You and I should expire well consider the price surface. Available to you even those who have written durability but will buy again when it is no longer cut off because the price is the price. We strongly hope the resale.
Chamfering of aluminum material
On 2014-04-30 13:21:12
I tried to the chamfered corner of the material in the milling machine, but scraping surface does not become a commodity in the irregularities. It is for chamfering and dish processing of the hole.
Tapping hole chamfering, deburring (SS400 and S25C)
On 2014-02-01 12:52:14
Use after the drilling of the SS400 and S25C.
Since entered the cheap hand at a bargain, it is satisfied with the cost.
Ideal for mild steel.
On 2013-09-22 21:07:29
It was purchased for hole chamfering of iron. Cheap because I did not expect much to, but was thinking about buying the next time because the beautiful face had been taken. Durability does not understand because still, such about 100.
Groove of material DURACON, hole chamfering
On 2013-05-05 07:40:28
Usually it is processing the aluminum material, but this time was processed DURACON material. We have a little happy about Bali after processing. Roughness of the cutting edge of the counter sink is now a little care. I would like to note at the time of processing a future aluminum material.
Chamfering after perforation
On 2012-11-15 13:06:34
Cost performance is good. Sharpness that can satisfy. Anxiety to sustainability.
Use the chamfered after drilling
On 2012-08-29 17:25:18
Sharpness is reduced without also 100 locations
It should of deburring has become in Bali with a tool.
We use in various situations.
On 2012-07-09 13:47:49
And it can be purchased at the disposal price am very satisfied.
Bonderizing 1.6 steel plate dish up of
On 2011-12-21 02:12:16
Frequency of use is not so high, but no longer lodged fell too early sharpness.
Other brand product, we regret that it was good if the manufacturer goods therefore have many years in the same use.
There are also good things in mono tallow brand but this counter sink, do not buy again.
Hole drilling of deburring
On 2011-08-26 12:21:29
I use normally.
For now trouble is not.