Due to the national holidays as Golden Week, we will close 2017/5/3~2017/5/5. This may cause delays with our responses. Thank you for your understanding.

Buy more than* S$200* and get FREE SHIPPING

Ultrasonic Cutter

4.00 (4)
Output Code (cm)
50 (Carl code)
Oscillation Frequency (kHz)
Maximum Consumption (VA)
Power Source (AC V)
Power Cord (m)
Maximum Output (W)
Outside Dimension (mm)
Oscillator (body) / approximately 134 x 127 x 71, the handpiece / maximum diameter of about 34 x 139
Weight (g)
Oscillator (body) / about 420, handpiece / (including output code) about 120
Blade (standard blade) x40 sheets, x1 or blade fixture, x3 or blade fixing screw, x1 hexagon wrench, instruction manual
...see all
Product Options
Ship pack of Mfr.# Item.# Sales Price Availability Qty.
Ship pack of Mfr.# Item.# Sales Price Availability Qty.
1PC 1 USW-334 10922983 437.98 SGD
In stock
Customer Reviews
5 star 0
4 star 4
3 star 0
2 star 0
1 star 0
Review Rating: 4.00
4 Customer Reviews
The reviews are automatic translation.
Cutting of plastic products
From Japan
On 2014-04-17 13:33:22
Street, which is also in the manual, is like not suitable for the cutting of thick material. Note that the tip portion is relatively quickly overheat state is required, continuous work is difficult. A little more, and even I think that usability is improved if there is room in the ability.
This review is about item#10922983.
Shape modification of plastic moldings
From Japan
On 2013-05-31 08:31:31
While you are using to cut a 2mm thickness of the molded article, but must press and hold the hand of the switch when you continue to cut, was hurt about the feeling of the fingertip is eliminated. Since the sharpness itself is very nice, much faster than previous work, to become to be able to comfortably, because the finish was also made to clean, they are generally satisfied.
This review is about item#10922983.
Various craft
From Japan
On 2010-10-27 16:00:34
Somewhat there are tips on mastering. Force in the feeling that "pressing and pull" rather than a "cut" is hardly needed. Five or six that's plain paper and put a force is easily cut. If the work to be cut is large, come in handy not tired fingertips. However, because the cutting edge is plastic because it has a heat cut melts somewhat, need shaping of the post-cut. Also, do not use the mat to remain deeply after the cut also on the surface of the cut Matta over. For quick and vital to finish the work, it is not suitable for fine and careful cut.
This review is about item#10922983.
Use a fine cut of the PP plate and ABS plate. Also it is used for the processing of car tail lamp.
From Japan
On 2009-06-18 14:40:48
And code to be used is a little longer, I think the more user-friendly is good if it is a soft material.
This review is about item#10922983.