The reviews are automatic translation.
Ideal for carrying the panel.
On 2018-02-19 18:28:21
There is more chucking power than I expected, easy to handle and angle easy to handle.
When reworking the metal plate and wanting to take out a resin box with a flat surface from the cardboard
On 2018-02-08 21:56:57
I think that we can do it at this price. I have only used it 5 or 6 times but I do not fade away and I think that it can be used quite easily because there is no air leak, I'm dissatisfied (small w wants to use)
On 2018-02-03 18:57:24
It was a big dent but I could pull it better than I thought.
Dent indentation of car
On 2018-01-21 16:18:35
It was hit by a bicycle and it was repaired because the dent in the width of 100 mm was created in the door on the front passenger's side. The degree of adsorption was not particularly problematic.
It is worth trying if it is a curved dent, but I think that it can not be handled if it is recessed at an acute angle.
Used to repair dents in car
On 2018-01-04 18:25:00
Car Noor Dent in the back of the right rear pushed by the light tiger It was impossible to restore it as it was for months but I found it on the web of Montalo the other day I started to repair quickly It is not noticeable in a few minutes I am delighted I will
Cure car dent
On 2017-12-28 14:58:33
I saw the way on the net and did exactly that. Eighty percent recovered but 20% did not hesitate yet another purchased thing.
Withdrawal at the time of sheet metal!
On 2017-12-19 18:43:14
A gentle dent is a very easy tool to pull out easily.
It is considerable satisfaction.
Repair of door panel
On 2017-12-08 20:23:03
Used for the door of a van purchased in second hand. I knew from the beginning that there was a dent larger than the palm size, but I purchased it as lucky if it became slightly inconspicuous with this product.
Clean the panel surface cleanly and then strongly press the cup and suck it as you expect. A small trigger was to remove the sucking cup.
If you push the trigger while pulling it and release the trigger as it is, it will become easy to suck. Workability improved by spraying water on the panel with water spray.
The point of dissatisfaction is that you have to press the cup to make it more dent to use it to return the dent. I was hoping for a mechanism that could make air inside the cup out of the way pumps were pumped, so it was disappointing there only.
Since the grip is die-cast, life expectancy will depend on the seal of the cup or trigger. Do not throw away the plastic disc that protects the chucking surface of the package, but install it every time and tidy up it will last long.
When sheet metal is corrected
On 2017-12-06 16:47:10
Used for dents, such as car doors, etc. For large dents etc.
It is a convenient equipment I recommend.
For floor panel opening and closing
On 2017-12-04 15:37:54
I purchased it and used it before, but it is re-purchase because I lost it
I was worried that the adsorption power was not much, but it was more powerful than I thought
I used two sucker things in the past but this one feel stronger