It was hard to hold the L-shaped hexagonal bar and it was short and inconvenient so I bought it exclusively for one. Because it is work in a narrow place, I made it a ball point type that can be turned even from an angle. I chose a magnet type to pick up the dropped needle.
Working on removable work of the carburetor linkage linkage section
On 2010-08-21 12:35:48
Because the grip is abnormally small and it is very thin, it does not take much torque to say at all. This was unexpected. Since it can only be used with the torque which can be rotated by thumb and index finger, it is not suitable for bolts tightened for fixing purposes. It might be good to turn bolts with low torque for adjustment.