The reviews are automatic translation.
Mechanical repair, metal processing, etc.
On 2017-03-01 15:13:45
Cheap and it is grateful. Items will be saved and there is a variety of shapes such as third-party product.
Development of bike
On 2017-02-27 16:00:01
It was used to sharpen the piston pin.
Pin is very hard, but it was shaved without diamond if problem. Angle also was just a good taper.
Cutting of internal bike engine
On 2015-11-19 21:11:40
Actually I Diamond Bar conical wanted, but was purchased reluctantly not only spherical in this amount of money.
There is no problem of cut with respect to use. However, you probably be enough if devise a sharpener way, I will be saved and there are things inexpensive conical if possible.
Polishing of aluminum.
On 2015-02-22 14:49:11
Eyes, so fine, but I felt likely to clogging,
And not, scraping crunch. Very, workability, is good.
Price is also, I think that cheap.
Detail processing of stained glass
On 2011-02-25 19:32:00
Get the diamond bar of the long-awaited 6mm axis (6mm axis is less product). Immediately attached to the router, it was commissioning, a large shake occurs. The end of the several times of trial and error, finally was queried in MonotaRo, there was a direct contact from the direction of the manufacturer. A result of those manufacturers who were tested, not a product issue, the overhang is too large (about the router 25mm only axis becomes the overhang is 55mm because it does not fit), performance can not be demonstrated it turns out the cause. The use of the product will be carefully taught, we had provided to bother materials.
Will be many things speak, and to try to take measures to reduce the overhang to cut the axis, was (bad source at) 50mm about cut (overhang is 5mm), no longer quite shake.
Towards the kindly support our manufacturers to not want trouble in amateur, thanks! is. In the future, I think that you want to use the company's products.
It is used to remove the port processing and aluminum edges and burrs of the internal combustion engine.
On 2010-11-16 19:49:47
When Nowak and gentle a little more R, I think that it is suitable for real work.