The reviews are automatic translation.
During maintenance work
On 2017-06-12 15:57:32
When installing the boot, if the adhesive got set fast and failed to insert it at once, it would not enter properly
On 2017-05-23 16:22:43
OJ-018GK I purchased and tried to replace it, but the size did not fit and when I contacted the manufacturer, it was an answer that Corolla Lumion would not fit. Because I have a website with a description of Lumion, I purchased it by mistake.
Drive shaft boots exchange
On 2017-04-17 09:45:18
I bought OJ - 023 GK, but the dimensions on the inner side do not match and I can not install it on UBS 69 Big Horn. Processing is required. Since each dimension is not posted on WEB, it is difficult to select parts. Also, please watch a little margin in grommets and include longer items, diluted. It is good to cut it for a long time.
Maintenance vehicle maintenance
On 2016-10-19 22:37:30
Although it is cheap, I think that this material can be made a little cheaper.
Drive shaft boots exchange
On 2016-10-10 22:21:19
It was very easy and it was pleasing to our customers without time
Replacing dust boots
On 2016-09-29 21:15:50
In the manual there is a expression "adhesion complete in 10 minutes". However, there is no expression like "Complete joining within __ minutes". After about 2 minutes, fusion has begun, and it is impossible to push in the place of insufficient pushing. "To complete the insertion of the joint from the beginning of sinking of the adhesive within 1 minute" is the point, and if it is reached it is re-purchased. I want a statement of this "within 1 minute?" It is! "Please pull the part of the mountain lightly after 10 minutes to confirm the bonding", but there is no description of how to respond when you get out. I would like you to describe how to deal with it! It is!
On 2016-08-13 17:33:56
To other companies' products, a thermal adhesive curing agent was attached, but this product was not, it took time to harden the adhesive and hard to install.
Replacing Drive Shaft Boots
On 2016-04-13 16:33:48
It was easy to exchange it. Grease leaks etc have not occurred after running lightly. I will take time to observe durability.
On 2016-01-17 21:23:57
The joint is not going to be exactly right now. If a large amount of adhesive is pushed in, it is difficult for the joint to come into contact and an unpleasant gap opens. With a little time I used the adhesive in the gap and used it, but as a result it took more time to fill the gap as it got better than I expected. I think that the amount of adhesive is too much, so be careful as it pales too much into the groove. I left it overnight after work and ran about 120 km, but it did not matter.
On 2015-12-10 16:16:34
The influence of the adhesive or opening of the fitting groove so that it gradually recedes.