Since we had installed a single lever mixing stopper so far, since water leaked out, it was newly installed in a handle type which makes it easy to replace parts. Even amateurs can exchange parts easily, so it was good to buy it very easy to use.
It is a simple mixed type faucet of 2 handle type. When trying to repair the water leak of the single lever type mixed faucet previously used at home, it was found that it was necessary to purchase expensive dedicated cartridges, and this "INAX 2 Handle Mixing Faucet" cheaper than that cartridge I decided to purchase and repair it. The reason for choosing the 2 handle type is that the repair cost in case of water leakage is much cheaper than single lever type. Easy to deal with when water leakage occurs because it is enough to exchange only about 100 yen of Cerep available anywhere and packing of water leak points. Like this product, a simple mixed water faucet of two handles type seems not to be popular, but it is a good recommendation to the person who emphasizes the repair cost at the time of water leakage and ease of repairing. Installation of the faucet is a very experienced work, so if you are not confident please ask the vendor. The tricks for replacement work at DIY and installation is to carefully squeeze threads with sandpaper of # 240 squeeze threads when wrapping the seal tape. By doing this, it becomes difficult for the seal tape to shift when attaching to a water pipe, making it easier to install normally. This is one of the techniques used by professionals.