The reviews are automatic translation.
On 2013-10-18 17:48:22
It is very handy to adjust, putting up square material and lifting it.
Router lift up
On 2013-09-27 19:43:40
I use it for up / down of the router attached to the router table. It is useful for finely adjusting blade height.
Laser marking height adjustment
On 2013-09-11 09:05:26
The adjustment knob is heavy. Since there are a few burrs behind the top plate of the press part, it seems that it will cut hands. There is more accuracy than I thought. Price is enough.
DIY drilling machine work table for raising and lowering assist
On 2013-06-26 20:14:34
Very satisfied with smooth operation. Some modifications were made according to the purpose, but the objective was 100% achieved.
Jig height adjustment
On 2012-10-02 11:19:15
Regarding Bali as well as other people are standing so that there is a risk of injury but there is no problem for use as a laboratory jack The price is also satisfied The attached nonskid sheet is also terrible dirty rubber full of scratches of yoreyeore Sheet It is a finish like made from waste material It is not even a square and it is a miscellaneous cut The value of laboratory jack itself is lowered. It is a level that does not need to be attached
Drill base of drilling machine
On 2012-09-20 17:58:13
When drilling with a home tabletop drilling machine, the length varies every time the diameter of the drill changes, so it was necessary to move the platform side up and down, which was troublesome. So, I purchased a lab jack and put it on this table, I thought that up and down movement of the parts would be easier. Although the edge of the stainless steel plate had burrs coming out as it was cut with a press, it was finished by scraping with sandpaper (electric), the problem did not occur. Immediately after purchasing, screws on the opposite side of the knob were cut to hexagon, and a 7 mm socket with 6.35 mm hexagonal shaft was attached. This makes it possible to move up and down with an electric screwdriver. I think that it was better if this processing was done in advance. When load is applied to the end, the rubber feet bow and tilt, so I think that I will change to a hard foot in the future. Products of the same degree are about 8,000 yen at others, and although this product may be bad in finish, it was able to purchase at the 3,000 yen level. It is suitable for those who can modify themselves, and I think that other expensive products are suitable for people looking for finish.
Adjust the height of the object to be photographed according to the lens position of the camera.
On 2012-08-17 21:49:24
Since burrs remained at the edges of the square stainless steel plate of the feet and the upper plate, it was put on sandpaper and it was removed. There is no problem with the function as a lab jack.
Adjustment of the height of the stand of the experiment tool
On 2012-08-16 16:40:14
I was anxious as far as I saw reviews of other people, but when I saw what I received in my hand, it was more than the price.
On 2012-07-09 17:31:40
Because the cut part was a sharp and scary feeling, it was very small compared to seeing it in the photograph which we chamfered at the file.
I use rails when carrying in goods, but we are using it to adjust the height of the rail.
On 2012-07-09 13:07:07
I am currently using it without any problem.I think I can withstand heavy loads and impacts, I will try it.