Buy more than* S$200* and get FREE SHIPPING
Due to the national holidays as Golden Week, we will close 2018/4/28~2018/4/30 and 2018/5/3~2018/5/6.
This may cause delays with our responses. Thank you for your understanding.
Reusable Screw System A Type Male Screw, Exclusively for 3130, 3000[x]close
On site assembling, because it is unknown length after installation, it was used. About 1 Mpa for hydraulic pressure.
On 2012-08-16 14:56:36
I applied the lubricating oil (VG 46) and assembled it, but when I turned the male screw, the hose became constricted on the way and it became frequent in Oshaka. I succeeded only for the first time, afterwards I assembled leaving the screw part about 30 - 40 mm. I do not have to worry because it is low pressure, but it looks bad. After watching HP, I wrote that if I look at HP it will slowly turn around, but I do not know how much it is. I am thinking that it is a hookey at about 60 degrees or less from the beginning because very torque is required from the way. There is no memo in the product that the assembly method described. Because it is summer, the room temperature is about 30 degrees. Is it vulnerable to heat? I used your product for the first time. I think that it was made in Yokohama rubber a lot but we used 200-300 (7 Mpa) plenty. There was one accident. I felt the danger, I stopped using it afterwards.