The reviews are automatic translation.
Seal washer such as brake
On 2017-04-27 21:56:45
There is no problem quality. Since it is difficult to obtain inch size in Japan, it may be possible to sell it if it is aligned with MonotaRO. Especially 7/16 "(≒ 11 mm) is a size difficult to substitute for milli.
Drain bolt of packing
On 2016-12-07 06:33:09
This article is the width of half of the genuine parts aluminum washer
Honesty, whether the effect of packing is there in this width? I was concerned with
Kind of not, but applications outside use is not available
Much trouble, I used to try things because you purchased
Of oil leakage, etc. There were no problems there
Is the advantage of because the waste value that can feel free to exchange for each oil change
However, it is not recommended for those who remember the anxiety for the tens of yen thrift
On 2016-03-11 19:41:58
Since the aluminum-to-use to bolt strength is I think that there is no, but I bought it because it was looking for something a smaller diameter than normal washer.
OIL exchange of Unimog 416, OIL exchange of Hafuringa, was used OIL exchange of agricultural machinery.
On 2016-03-09 19:18:44
Had used a copper washer, but it is good condition bite well in the member towards the aluminum is the other party.
It also used in the fuel system. Since it used 10 sheets alone around one of the legs we use cheap and of aluminum.
Improvement is not, we will also not be used if any of or greater small inner diameter as having.
Engine oil drain
On 2015-09-11 19:11:42
Thin because re-use is severe.
Replacement of drain plug
On 2015-08-07 17:47:35
Cheap and I hope it is a thin be a little thickness can not be used if the number is too large
On 2015-03-28 07:44:12
Thickness is a little thin compared to the regular goods, but it can be used without any problem. Honda uses to Suzuki.
It uses the engine oil change.
On 2014-11-20 16:40:21
At first I thought the thin, but I am satisfied with this product because what is also no problem using.
Price is also good cheap.
On 2014-11-08 21:10:59
It is want at least 1.2 or more if thin a little more thicker
Car of the oil drain plug
On 2014-09-02 19:16:48
Certainly thin. 1mm thin. In drain plug washer, because the degree of tightening in the Well ~ 40Nm, but I try. Feel likely to cut too tightening it is.