The reviews are automatic translation.
On 2016-05-05 17:57:16
It can be used normally.
Used for motorcycle mission oil change
On 2013-11-18 14:19:56
If you have this in oil injection or brake maintenance which is difficult to put in, it will be very successful. I do not need anything long, I can inject it more easily than a dropper even in cases where the inlet is beside and difficult to maintain. If you pull the cylinder with the same liquid, you can inject it as many times as you like, after disposing it it is easy to dispose of it so it can be used easily. A special tool is also nice, but as it can be used for a variety of these applications, it is convenient. If there is hope, there is no complain if it can be purchased in smaller divisions.
On 2013-08-16 15:05:14
It is hard to wash when washing
It is used to collect a fixed amount of sample water when measuring the hardness of water.
On 2013-06-17 17:34:11
With no needle syringe, without rubber packing, you do not have to worry about contaminating impurities. Very useful for collecting sample water quantitatively! It is!
For wild bird rescue
On 2013-04-19 11:42:59
Sorry about unused as same as another size. I was looking for food to replenish in a situation like a liquid food.
Suction removal of oil sump in engine
On 2013-04-11 23:14:44
Since the inside suction part is not rubber, there was anxiety about suction power, but its use disappeared when used. I think that it is a construction with considerable precision. Capacity is as large as 501 ml, so it can be used for car relationships sufficiently.
On 2013-04-10 00:36:47
Purchased for use in grease-up of dust boots etc. Because it is a small size it can be injected into a little gap, it seems strong also to medicine because there is no rubber. However, since the cylinder part is also made thin, it becomes difficult to move by pinching strongly with your fingers. Usability is good, I think that the price is cheap.
Quantitative filling of adhesive, sealing agent etc.
On 2013-02-15 13:49:16
The nozzle diameter at the tip is small, and it is easy to control the amount. I think that it matches well for the filling of those with large amounts such as sealant.
Fluorescent agent injection, gap injection of plastic solvent etc.
On 2013-02-15 13:46:45
There is no sagging in the injection, and there is no worry that the piston will be melted in drugs (solvents) etc with all-plaque and I am very grateful. I think that it is indispensable for quantitative injection control.
For PVC adhesion
On 2013-01-23 14:57:50
We used a solvent to bond PVC board, but before we used glass syringe, but it was still glass, so it broke down as soon as it dropped inadvertently. That product is safe because there is no worry about breaking this product. However, if you do not pay attention to the beginning of the liquid out, the solution will jump out vigorously, so that point is a negative point.