The reviews are automatic translation.
On 2017-01-20 12:43:16
Mono of finish that was printed in the 3D printer
On 2017-01-14 12:17:44
To finish the things that were printed with a 3D printer (PETG system), water-resistant paper (No. 240), sponge polishing agent (No. 240), uses some sandblasting (# 180).
Although the plane is the easy-to-use water-resistant paper is the best, outside surfaces and in particular the inner surface becomes tattered and broken water-resistant paper, so further scratch the things, I use a sponge abrasive.
In addition, water-resistant paper is shed abrasive grains (SiC) is black, I stand out when entering the clearance of goods, sponge abrasive does not stand out so gray (Al2O3).
Break the surface of the wood
On 2017-01-05 14:48:23
The skin with uneven plain wood and the like have raised many years of dirt and grease from, polished very easily finely, can be leveled.
Polishing of the shaft
On 2016-12-16 08:54:37
Shaft, etc., because that can be very beautiful in a short period of time is circular polishing easier, will use carelessly without the use of sandpaper.
However, because it is expensive compared to the sandpaper, the purchase of a box unit was the best.
On 2016-12-08 15:04:55
Compared to 3M, abrasive is likely to peel off the wet to use.
Use the curved surface of the sanding in woodworking
On 2016-12-05 09:14:09
Manufactured by 3M and inferiority and be used without, is nice COSPA. If so it can be used on both sides, but I still say.
Racing cart rear shaft polishing
On 2016-11-08 19:40:02
You can use the time to polish the scratches had been able shaft. In addition, finishing sponge polishing agent of "# 320 to # 600 equivalent" was the best.
Faster wear when compared to sandpaper, I quite expensive, the ease of polishing of the curved surface is not a ratio of sandpaper, since the polishing of a relatively wide range can be performed with ease, it is very handy.
When the paint job
On 2016-10-30 23:19:43
It was previously bought continue to those of 3M Company, but was just completed a purchase of Monotarou Review reference think about equivalent to 3M. It has been specified in the once British manufacturing and the box. Added purchase. In the future we plan to continue here.
Polishing woodworking work
On 2016-10-25 20:29:38
I'm using a sponge abrasive to edge up in its trimmed part in coping saw, but you can use without steel and comparable 3M.
During the paint work, used at the time of maintenance of the machine
On 2016-10-04 10:23:49
It was very easy to use normally.