The reviews are automatic translation.
On 2014-07-17 00:58:26
But was that ratchet specification, to actually use as a ratchet is unreasonable. Hesitation to use to perform the bolt size adjustment.
On 2014-05-07 15:34:30
Not bear to use, had imperceptibly parts also become apart
On 2013-01-06 21:26:29
Very practical and I do not have, to lick immediately when you turn the rusty bolt, it will not fit immediately size in the normal course.
It is for the play, but interesting if children use in play, you can not use 120% at work.
Tightening experiment jig
On 2012-10-06 16:58:49
Everyone street posts, I also feel and there is difficulty in durability. It has damaged (usually one hand can be assumed without the momentum be said) work a little stronger.
In addition, it is a catch-phrase that can ratchet used in a continuous, so do I need to adjust the tightening of frontage while using, only the adjustment amount of close to open normal monkey wrench is small, it does not change so much time and effort .
Because I think that it is an interesting tool as a temporary tightening of the toy, I think that it is good to play for rattling in the do-it-yourself store.
And enjoy shows than the allowable torque maker, to understand the pre-purchase consumer that the temporary tightening tool, I think that it was good.
Tightening of the bolts
On 2011-10-23 18:28:22
The size to fit the hand of the wrench was used to tighten the 27mm and 30mm of the nut without.
It might have about five months has been improved by use of purchase, but it does not bear to use.
You begin to turn to fit the size of the nut will slip licking the corners of the nut to the third position to open the mouth size of spanner in every once ratchet. By adjusting the mouth for each ratchet once you this tightening, but it does not bite is not then also you have mouth size when you Shimeyo the nut of the same size is narrower adjustment.
Is licking the corners of the nut was nailed oodles just in the vicinity of the material in this clamping position, it was Hiyari thing because it was aerial.
I tried to tighten the nut of 19mm in the trial, but was the same.
It will use if the use of the ordinary wrench without a ratchet is not turning in the opposite direction in only one direction even if the.
Maybe you'll no longer using, it is dangerous.
Bolt of tightening loose work
On 2011-02-07 21:58:03
Moderate friction can now be born ratcheting By changing the riveted to M5 truss screws to narrow the gap between the monkey and the grip. At the time of manufacturer production I think that may reduce the backlash, such as narrowing the gap between the rivet.
Bolting loosening of
On 2011-01-20 19:01:17
If slowly ratcheting, but does not change too much size, size is mad as soon as the fast. Warm backlash even greater, since weak all of the spring, I think this is a design mistake. I think in a little better if the spring strong?
Bolted other machine / tool General
On 2010-12-23 13:46:15
If the accuracy is turn is set to once bolt low from the second rotation is now when the engagement of the tooth is trying to rattle set the bolt of the same diameter habit that will loosely normal if such a thing difficult to use anyway become narrow in width has defintely good your products towards the monkey were various buy even one yen if all when it is grasped such a commodity is bad'm at is ... such a thing is intends Mazukaro intends Yasukaro that would look the same I do not need