The reviews are automatic translation.
Drilling in thin wood
On 2017-03-07 21:22:13
When trying to open a through hole towards the end of a thin wood, if the tip of the center is screw type, it will spread too much to spread and it will not crack. However, because we do not call wood, the cutlery can not be cut, but it is better not to use it for hardwoods because there is little power when drilling. It is cheap and excellent in cost performance. I also sell it to a neighborhood home center, but buy it here. Although it has not broken by normal use at the moment, it is not an iron core cone so if you hit a nail it is truly lacking a knife.
On 2016-12-11 14:43:44
Only 3 mm was enough. I think that it can be used for something in the future.
DIY carpentry woodworking work
On 2016-07-31 22:40:21
Because of the characteristic tip shape, it takes more time to drill than other items.
On 2016-03-27 11:25:15
On 2014-10-08 08:37:58
Although it was not a problem to use it on a thin plate, I broke three pieces at the age I used it for thick wood with clogged eyes. Was the way of use bad?
Drilling with a tabletop drilling machine
On 2014-05-09 16:44:10
I searched for a blade because I wanted to open the diameter which is not stiff enough to accommodate the chuck. I think that there is no problem in use and cost performance is the best in the site.
Used for making wood fixtures.
On 2012-01-19 18:23:18
Since it has a two-piece structure of round shaft drill + 6.35 mm hexagon up to 6 mm, because it is a structure that fastens the two with a roll pin, when high torque is applied at a node etc., the pin breaks and becomes unusable. (Occurred in 6 mm) 7, 8, 9, 10 are one-piece and can not break right now.