The reviews are automatic translation.
On 2017-07-08 08:43:04
Is it a drawback that being accustomed to making it to the desired length, not being a substitute for the flat belt, and being difficult to handle the bulging of the joint?
Machine change belt
On 2017-07-07 14:28:52
I can use it normally. As a request, 10 m is too much, so I would like to sell it in decimal such as 1 m unit.
Used for rotating parts of machine
On 2017-06-20 20:28:22
It is somewhat harder than the other belt, but it can be used without problems.
After that, how durable it is.
Transmission of rotational force
On 2017-06-18 19:04:27
Easily melted with a lighter and connected, I was able to make a belt of the required length.
Power transmission of engraving machine
On 2017-06-02 14:50:40
I used it for an old-fashioned engraving machine. I could easily joint it more than I thought.
Replacement of transmission belt of rotating sign
On 2017-05-26 14:52:28
Because the belt connecting the motor of the rotating signboard turning slowly at the shop and the rotating shaft extended and the power ceased to be transmitted, I thought about belt exchange and came to this urethane orange belt when I was searching. Together with the stretched belt, think of join shi, cut it roughly. Rubber gloves and rub it with a lighter. Just join when the fire gets on the end face, change the angle of view and center out, shaping the part that has melted out with fingers, shaping with the fingers, covering the joint part and finishing with strength reinforcement. I did it quite appropriately, but I'm going around a rotating billboard. We made two reserve and it is the end. Ideal for places where less accuracy is required. Outstanding cospar, it is super recommended.
Audio equipment repair
On 2017-05-25 08:26:08
MD insertion and exchanging that the belt of the discharge mechanism was stretched. Once failed, you can easily make a belt by fixing the heating part, safely working, repair completed, you can use.
For repair due to breakage of the belt of the stand drill
On 2017-03-25 21:04:58
I could not find a belt with a good length and I could not use the stand drill, but I left it, but now I can repair it. It was saved because we can secure reserve as consumables.
Dedicated thermal printer to drive transmission
On 2017-03-24 14:01:39
Dedicated belts are imported items, so it is quite difficult to obtain them. We are currently using it for steady use.
Repair of DVD deck
On 2017-03-21 08:46:44
It has a length of 10 m and it is inexpensive, but if you have 1 m as well, you will feel a bit misleading because it is enough. Also, I am worried about how long it can be kept.