The reviews are automatic translation.
On 2016-07-29 18:23:30
First use is good, but can not be used in about half. Scattering often.
On 2016-06-07 19:38:02
It is absolutely no complain!
Although somewhat inferior momentum in the upper still when compared to the one on the grade is the satisfaction quotient material to say clearly.
If I am allowed to say only one thing I think that there may be more rough eyes.
On 2016-03-14 18:40:04
Helicopter is is early, but I think reasonable even if viewed from the price
On 2016-03-03 23:14:53
Shipping also I think that may be early Monotarou's commodity repertoire. We have a variety of merchandise purchase every month.
On 2014-09-07 16:38:36
Use cheap because it was good
It dropped stubborn rust
On 2014-05-05 16:21:34
For us down firmly bite to stubborn rust.
On 2014-03-07 22:59:36
It is the best in the Toka little deburring.
Deburring of the cut surface of the steel material
On 2012-10-31 00:05:36
It was purchased because there was a domestic paper use, but there is no paper itself only by taking several beams flat bar.
Cruel too was the quality, than this is still better of Monotarou original alumina disks (although you will not immediately be compared, even for an earlier ...) I bought six this, one alumina disk in six it was a minute degree of durability. Actually is from the test I want you to commercialization, anyway terrible!
Bead of grinding, take scratches rough, surface preparation
On 2012-10-26 19:09:35
Monotarou brand of was using the blue label, but this time I tried to buy the test here. Unfortunately, there is a difference in quality than price difference.
Compared to paper thin width as that of the blue label also it seems narrow as 1mm. Therefore there is no thickness, but the price is not cheap minute how the point.
Weak grinding force compared with the same 40♯, it does not have the sharpness of the specific grinding immediately after the start of use of the new. I think the impression that you use that it is 80 ~ 120♯ about cutting force of manufacturer goods.
Perhaps it is preferable to use a soft material such as steel end of the chamfering or aluminum-wood, but I think that there is no sense to use that it is it the zirconia.
Polishing finish of welds
On 2012-02-23 13:08:06
It is very well shaved commodity considering the price. Monotarou is an intermediate price brand of zirconia, but I think the No. 1 good.