The reviews are automatic translation.
On 2015-06-29 17:58:03
Rising even faster, no problem.
Futomono solder work
On 2014-11-14 08:37:39
I am very satisfied
I was looking for a soldering iron of 200w in a small
Car of a wiring, or the like
On 2014-10-10 17:38:43
It survives because the ready-to-use Power. However, hope is improved because the button is hard to press.
Soldering work of a defective condenser replacement and wiring of the PC motherboard
On 2013-03-08 23:22:36
Early rise, impeccable and faster switching of the reaction of the push button.
However, from buying what frequency of use were too many broken in about one month.
The price basis only to have be satisfied with low-cost, it was a regrettable I think the durability of the low.
Soldering of copper wire
On 2013-03-01 13:11:54
Also of about 10 ℃ in the room will rise by about 10 seconds.
Kana may be left of the current because the trigger type of not pressed, easy-to-use but in time long towards the switch.
It is still by far better than that of the things you do not use only a few times that has been previously used.
Not yet soldering of the big game, but is less affected around since the amount of heat firmly there seems time can be soldered short.
Work of the defective condenser replacement and wiring connections and the like of the PC motherboard
On 2012-12-10 09:22:25
I think the pros and cons break up, but I is the easy to use is more of the cancer type? I think, although I tried to buy to try, I see the hand felt easy to use and less tired if a long period of time of work.
However, if you use while holding down the power button with your thumb, I think that some of the familiar is required to stabilize the tip.
More ease of use, if such type power button pulls the trigger would be improved.
At the same, but there are a high-quality domestic products to the item description, I did not feel that the higher the quality say.
In fact, now useless in the three months to buy.
Might I of overuse, but ...
Code and a stainless steel plate
On 2012-12-07 14:13:36
Rising is fast, is easy to work.
I think of price to be
Mainly used as a soldering of the microcontroller board.
On 2012-11-25 00:30:54
Immediately, it was used in the soldering of the substrate.
More of a feeling of use, the solder work of detail is now very easy.
I think I was able to good shopping.
Repair of vehicle relationship
On 2012-10-29 13:08:18
From 20W to 200W it is good to be able to switch in Wanpusshiyu.
It is very nice rise
Soldering of electronic equipment wiring
On 2012-08-14 13:35:52
Stability is impaired this time of the grip and the power-up switch to press and iron things with your thumb soldering efficiency drops speedy in.