The reviews are automatic translation.
On 2015-11-25 15:19:41
It is not now to price also goods also was good, I'm sorry
Aluminum plate drilling
On 2015-01-03 22:04:17
Will this mon because it is inexpensive. It may be thorns if not cut.
Screw down the aluminum plate and punch down.
On 2013-01-22 21:19:07
It is such a price like price.
Impact charging drill
On 2013-01-13 12:31:58
Hole drilling is done, it is used for sharpening frequently whenever it is chipped frequently, but in case there is no grinder or because it is troublesome during high altitude work .... It is safe even on the go because there are so many cheap numbers.
Sheet metal · roof construction
On 2012-12-01 11:38:16
Thick 3 ㍉ stainless angle angle was also able to drill thoroughly. Hitachi Impact If you set the tightening power of the driver to 1 in 4 steps and rotate it at ultra low speed, the hole will be comfortable with the stainless steel. Even when polished, the sharpness does not change, and since it is rust-resistant processing, I think that it can be recommended for those who use it at outdoor construction sites.
Drilling at the construction site
On 2012-01-16 19:26:51
I am still using it, so I think that durability and so on have not been confirmed yet, but sharpness is okay. With this, I think that it is recommended by all means if durability is good.
It is used to open a steel plate hole of 1.6 to 3.2 mm.
On 2011-11-26 21:02:01
Drill cutting oil at 6.8 mm (MonotaRO) after piercing 3.3 mm (made by other company). Hexagonal shaft and dust were pokkiri after that and then 4 pieces were used, and it was finally possible to drill a hole. It is too weak. Even if the dust is 6.8 mm, it is 3 mm at the joint with the hexagon shaft? It is only connected to it. Is there a reasonable strength? I want you to increase the strength by making the integral structure of the drill and the shaft or thickening the junction. After using broken dust on an electric drill, it got well. Even so regrettable.
1.6 mm drilling work of iron plate of about 2.3 mm work Distribution board raceway
On 2011-09-25 10:15:19
Although it was good at the beginning, the cutting powder became small and it went bad at 10th - 20th place. I tried the second one, but it seems that the 100-year-old Kiri who lasted a long time lasted long. I want you to have a sharpness last longer.
Drill holes in iron and aluminum, and stop the screw.
On 2011-08-23 02:20:49
Sharpness is pretty good, but if you put too little strength you will bend.
Drilling of iron plate etc.
On 2011-07-20 18:47:55
Easy to install on impact driver and work smoothly