The reviews are automatic translation.
To heat the heat-shrinkable tube for cable reinforcement
On 2018-06-11 09:34:40
I am satisfied with both the temperature and the air volume, but if the temperature is too high or if it is used for business it will cause disconnection of the Nichrome wire. I think that it will be extremely quick to break even compared with other companies' products. I asked for improvements a number of times, but I was not able to improve it, I think that the idea of a private brand is incorrect.
For shrink tube processing
On 2018-05-26 14:39:04
I used lighters and soldering irons to process shrinkable tubes, but because they were not able to do so, I was checking to buy a decent tool at this time, but since there was a thing of monotaro, I purchased it did. It is cheaper than the other, but it was able to clean up cleanly. Cospa is expensive.
On 2018-05-26 14:33:50
It is the third unit for work. Although it is cheap, both three units are active.
On 2018-05-21 19:21:32
It seems that the temperature is being adjusted by changing the number of times the heating wire is turned on and off by volume with strong wind 1500 W, weak wind 700 W, weak blowing.
Processing of heat-shrinkable tubing, bending of water-cooled PC pipe
On 2018-05-18 15:03:18
Temperature control dial is intuitive operation, easy to use.
Also, it is saved because it stabilizes as it is when you use it by holding it in your hand.
Normal Maintenance of Motorcycles
On 2018-05-08 14:38:51
Thank you very much for your immediate delivery. Also when you order next time thank you.
Purchase cheaply with campaign
On 2018-04-19 16:27:08
Products of the same spec can be bought cheaply. great. The calorific value is also very high and it is active in various scenes.
When drying the putty, when pasting the decorative film
On 2018-04-11 15:00:46
Previously I used high items, but this is cheap but easy enough to use.
Heat shrinkable tube work etc.
On 2018-04-10 09:52:27
I am satisfied with the ability, no problem.
However, using this heat gun (1500 W), the fluorescent light blinks ... · · ·.
It was not felt at Ryobi's hot air gun (1200 W, purchased personal items 7 to 8 years ago).
Is it due to our power distribution equipment being poor?
While using it as a breaker will fall.
Drying of paint to iron plate and bending of PVC pipe
On 2018-04-05 19:13:36
Both calorie and air volume are satisfactory.
I bought a few years ago ordered the second car yesterday because life has come due to deterioration of Nichrome wire.
However, I am glad that processing of PVC sticks is easy if it comes with the nozzle's extremely fine.
So four stars.