The reviews are automatic translation.
Tap created in steel
On 2015-10-24 19:53:50
Less likely to break than the spiral, it is less variation in quality.
Tap changer use of Hinotoban bis
On 2014-10-16 18:04:11
Easy to understand from the tool box have entered the case. It is suitable for impact use for the hexagonal axis
Door closers exchange other
On 2014-04-16 16:42:48
Since the frequency of use is often a higher price is cheaper use satisfaction.
On 2014-01-29 23:11:56
Without any blurring of the standing axis, may be cutting
On 2014-01-05 16:27:34
Cheap is good goods. It is not the same as the expensive ones.
Tap changer of Hinotoban bis
On 2013-08-19 13:16:42
You easily can tap changer but wonder if easy to use better long even 5mm little more tap part?
On 2013-05-27 09:07:08
It uses the threads fix the collapsed. This is early work because Mawaseru an impact wrench.
In charger, used in low-speed rotation.
On 2013-03-04 21:33:14
In charger, used in low-speed rotation, broken (five in two while in the third round
Threading of iron plate
On 2012-11-08 16:09:37
Tap is cut well, but does not match the pitch of the pitch and bis tap. Turning about one to two rotating screws, becomes heavy, not not enter bis. The tap cliff again with another tap, do you need to.
SS400 screw off to such
On 2012-02-10 21:00:55
I could not even pierce one unfortunately
This product, carefully rotation of the machine because it was the first time slowly
It was rotated, but it was broken without any resistance
It was terrible because it was the work of a hurry
Monotarou brand of tap seems to have bad quality on average
* (Monotarou branded coating is not be used yet)
... Or threads, if not broken finished in the rough
Greater cutting resistance or ...
It is a better tool that price can be used with confidence even more than twice
Unfortunately that will cost up When you use this knife
Also I would like to buy if there is information of quality improvement