The reviews are automatic translation.
Shrinkable tube processing
On 2018-03-02 21:59:19
Hot air burned out in one month of purchase. It is about 1 minute × 30 times use.
Is it broken if the blast time is short after use?
For heat shrink
On 2017-12-19 17:15:18
It is fairly light, and the handling is also good. However, it takes some time for things with a large target area to irradiate with hot air because the air outlet is thin. It seems that the one of the cancer type is higher in the powerfulness, but it seems that it can be used enough if it is about the hobby use degree.
For electrical wiring shrink tubing
On 2017-05-22 20:58:58
This is just right size. This is enough if it is the amount of personal taste used. Lightly, it stands on the desk. Both manual work is also possible, it was good to buy.
Used for shrinking heat-shrinkable tube during wiring
On 2016-12-12 15:23:35
It is very light compared to the conventional heat gun. Because it has a hexagonal guard, it is very convenient because you can heat it while it is on the workbench.
For small insulation of small articles electronic board
On 2016-12-07 08:54:47
Purchased for easy insulation of accessory electronics with thermally shrinking tube. The base with many openings such as connectors is difficult, but it was easy to put in the tube if it was a base like a dry battery.
Used in shrink tubing
On 2016-12-03 17:42:12
It shrinks the tube about 3 to 6 mm well. Even a place with a temperature of 10 ° will do a good job. It is handy because it fits easily in the tool box.
Shrinkage operation of heat shrinkable tube
On 2016-07-27 08:47:48
Although it is compact and easy to handle, on the other hand, it takes some time for the heat shrinkable tube to shrink as the amount of hot air is small and the hot air spot is wide.
Heat shrinkable tube
On 2016-01-14 19:48:07
It is handy because it is light and does not take storage space as much as there is no handle. For the hobby it is enough for performance.
Heat shrinkable tube processing
On 2015-10-24 07:08:24
It is mainly used for heat shrink tube processing of shield contact part. For good-looking and polite finish, we use plastjet mini and heat gun for large amount of processing. I fix it like a desk (like hanging) but I am pleased that it is compact and easy to use.
Sumitube nameplate for peeling
On 2015-10-21 17:22:48
Handle is slightly inconvenient (using) but much better