Carburator Vacuum Gauge Set
* Products that meet your criteria are shown in table below.
- During use, make sure that the adjustment valve is fully closed, before starting the engine. Please perform adjusts while following the service manual. When in horizontal state, it may or may not deviate from the zero point. Please use it perpendicular
- Gauge Diameter (phi mm)
- Measuring Range (kPa)
- -100-100 (10-5 Ticks)
- Dimension (mm)
- 300 Full length x full width 150
- Set Contents
- BODY (WITH ADJUSTMENT VALVE) (BRASS) ATTACHMENT: 169 x 4 x 4 (END OF TAPERED), phi ATTACHMENT MOUNTING SCREW SIZE: M5 x P0.8, M6 x P0.75(*PLEASE USE THE GENUINE YAMAHA for M6 x P1.0 ) .), VINYL HOSE: phi 5 x 8 x 950 x 4 BOOKS phi FOR M6 FOR O-RINGS (FOR ATTAC
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
4 Customer Reviews
The reviews are automatic translation.
Maintenance adjustment of the carburetor
On 2017-04-05 16:21:54
It can not be helped because the cheap, there are variations in the accuracy of four meters. We use the reference level.
Balance of multi carburetor up
On 2015-05-08 00:07:55
A feeling of use and operability itself was available without any problem once you get used, I think quite high reliability.
Two of the needle in the four there meters, had a hard time considerably since they must be adjusted by subtracting the minute has been quite center shift.
It survives quite as possible fine adjustment of the needle, you, but have been covered by the minute workmanship cheap and nasty.
Adjustment of the carburetor
On 2014-05-07 14:27:46
I find the thing I was looking for ease of use is also excellent. I did a good buy.
The development of motorcycle as a hobby
On 2014-04-18 13:45:27
I think Daytona of products that so reliable, there is no thing so different from a feeling of use is on the market.