As motorcycle headlight ... ... it will not be used.
On 2017-05-30 20:29:41
I wanted a motorcycle headlight with a lens diameter of 130 mm with a classic appearance, but this has not reached the level that can be practically used as a headlight or performance. First of all, the plating of the reflecting mirror is not glossy like satin plating, it is not a mirror surface. Although it is not like zinc plating like a truck backlight or a shoulder light but it is like nickel plating, it seems that it is made by a handmade recipe not doing the ground polishing to the log. Furthermore, the cut of the lens is not sharp but vaguely finished, it seems that the mold is aging. Because of that, the control of the spread of light etc. is not enough, I will not illuminate the road properly. The plating of the exterior light trim also looks shabby looking mostly around the outer periphery without gloss. It is inconvenient that the bulb (light bulb) is not used at the moment, it is inconvenient that it is P 30 d - 10. 3, and there is no knob or slip to make the knob easier for the part to hook the fingers to when detaching, so workability is very bad . Earth is a body earth and has only two electric wires. The inner diameter of the rubber grommet in the hole that draws out the wire to the outside is as small as 6 mm. It does not seem to be a defective product, but its performance level is too low, so it is totally useless, it is as garbage.
I bought two on the auxiliary lamp of my car, but there is no manual and no light bulb, I do not know which bulb to buy, I tried variously, but listen to someone familiar with the car I did not know which lightbulb, and I did shopping in vain at all. It is a garbage can go. I replaced it with another one with a light bulb. I want you to say that there is no light bulb or what bulb you should buy!