The reviews are automatic translation.
Additional machining of surface hardened machined parts
On 2017-05-06 19:38:00
It was able to process as expected with a strongly twisted object.
On 2017-03-24 17:01:51
There is no problem. In addition, we would like to buy.
Use in machining
On 2017-02-21 16:15:53
Monotarou brand Toka lacking, but there is also evaluation of Toka consumed quickly, I think that there is no problem if used in the finish after roughing. Because occasionally shortage comes out, always I want you to check inventory.
On 2017-02-16 15:13:57
Cost performance is good think.
Although tooth when abuse is pain
On 2016-07-09 16:30:31
Cheap and fast and I hope, but the blade of pain
2017 cutting cut out of
On 2016-06-10 21:07:14
Bite of the blade can be high-speed cutting is very good. COSPA It survives well is.
On 2016-02-17 17:31:31
SUS316 of the spot facing 53 places gave me doing blade spilled one without a single. You can use!
On 2014-10-17 19:58:49
This 45 degree screw fasteners have been used for a long time since then, but the package has changed from the purchase amount this time, and the appearance of the product itself is clearly different. When cutting is started, the cutting edge suddenly becomes chipped, and the surface of the processed product also rattles. I switched to the end mill of the old package which was stocked on the trial, and returned to the previous processing quality. Perhaps I think that the manufacturer has changed, but the price has risen gradually and it is about 1.5 times, it does not function as an end mill at all and, at present, it is not worth paying for 1 yen on this product.
Processing of S45C
On 2013-11-22 23:31:22
I bought it because there is only 30 cheap cutting blade lengths. Sharpness seems to be nice, but streaks enter the side. I used it after roughing by roughing, but I can not use it for finishing. The bottom is patchy. It is a little disappointing with similar products of other companies because it is not like this. But it's super hard, so efficiency is good
MDF sheet shape cutout
On 2012-05-19 14:02:18
Since it is a 2 mm end mill, Z feeds were sent by 1 mm each to 5.5 mm and cut out, but strips of Z feed interval are attached to the cut surface. I do not know whether a part of the cutting edge in the 4 blades is slightly off the perfect circle or whether the part of the tooth is different in sharpness, but even if you purchase two and use it while replacing it the same result was. I am back to original and I am using a 2-bladed end mill, but since it was a long time ago, there is nothing like that, the surface is beautiful as far as I can not understand the Z feed interval at all. It's only 4 blades with a helix angle of 45 degrees so you can increase the speed of cutting feed. It may be that I myself have not fully grasped the characteristics of two blades and four blades.